OSHA Quiz: Can You Use a Stepladder as a Straight Ladder if Someone Foots It?
Scenario: Can You Use a Stepladder as a Straight Ladder if Someone Foots It? A stepladder (which is a type of’ self-supporting ladder) is used as a non-self-supporting ladder, but the bottom of the ladder is either “footed” (that is, another person keeps their foot on the bottom to keep the ladder from slipping) or the ladder is tied off at the bottom to prevent the bottom from slipping out.
Question: 29 CFR 1926.1053(b)(4) requires ladders to be used only for the purpose for which they were designed. Some manufacturers have indicated a concern that a self-supporting ladder might slip out and cause someone to fall if it is used as a non-self-supporting ladder. But would the use of a Stepladder as a Straight Ladder as described above violate 29 CFR 1926.1053(b)(4)?
OSHA’s Answer: In 29 CFR 1926 Subpart X, 1926.1053(b)(4) states “Ladders shall be used only for the purpose for which they were designed. [Emphasis added]”. Thus, using a stepladder as a non-self-supporting ladder would violate §1926.1053(b)(4) if the ladder were not designed for that purpose. The particular design of a stepladder varies from manufacturer to manufacturer. Therefore, whether or not the scenario you describe constitutes a violation of §1926.1053(b)(4) would depend on whether such use is consistent with the purpose intended by the manufacturer.
It is our understanding that self-supporting ladders, including stepladders, typically, are not designed to be used as non-self-supporting ladders unless otherwise indicated by the manufacturer. For example, note that paragraph 126.96.36.199 of ANSI A14.1-1982 and ANSI-ASC A14.1-2007 state that, “[s]elf-supporting ladders shall not be used as single ladders or in the “partially closed position” [emphasis added].1 Note, also, that ANSI-ASC A14.1-2007 defines “single ladder” as a “non-self-supporting portable ladder, nonadjustable in length, consisting of one section.” Statements from manufacturers indicating a concern that a self-supporting ladder might slip out and cause someone to fall, if used as a non-self-supporting ladder, would be consistent with these ANSI provisions.
Typically, having a coworker hold the ladder, or using rope to attempt to restrain the ladder at its base, would not be considered substitutes for this requirement. We note that, for example, slip-out is not the only hazard that can result from using a ladder differently than in accordance with its design.
Furthermore, 1926.1053(a)(2) states: “Ladder rungs, cleats, and steps shall be . . . level . . . when the ladder is in position for use.” [Emphasis added] Stepladders are typically designed so that the rungs are level when the ladder is in the open and locked position and the ladder is placed on a stable and level surface. Consequently, it is likely that positioning a stepladder for use as a non-self-supporting ladder would result in the ladder’s rungs being out-of-level, which would violate 1926.1053(a)(2).
Supporting documentation: OSHA Letter of Interpretation